HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 155
Try reseating the blade
If this is a valid blade and reseating doesn't help, then replace the blade
Severity
ERROR
FABS-1014
Message
Probable Cause
An unrecognized of FRU has been discovered in the system.
This may be caused by an incorrect FRU header, inability to read the FRU header, or the FRU may not be
supported by this platform or Fabric OS version.
Recommended Action
Verify that the FRU is valid for use in this system and this version of Fabric OS
Try reseating the FRU
If this is a valid FRU and reseating doesn't help, then replace the FRU
Severity
ERROR
FABS-1015
Message
Probable Cause
Indicates the specified FRU could not be enabled. This is usually an internal Fabric OS problem.
Recommended Action
Try removing and reinserting the FRU.
Reboot or power-cycle the CP or system.
If the message persists, run the firmwareDownload command to update the firmware.
Severity
ERROR
<timestamp>, [FABS-1014], <sequence-number>,, ERROR, <system-name>,
<Method name>[<Method tag number>]:Unknown FRU type 0x<FRU Object
type>
<timestamp>, [FABS-1015], <sequence-number>,, ERROR, <system-name>,
<Method name>[<Method tag number>]:Request to enable FRU type
0x<FRU Object type>, unit <Unit number> failed. err code <Error
code>