HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

146 Error messages
Probable Cause
Indicates that the application exceeded RDI (request domain ID) requests for the insistent domain ID. All
E_Ports are disabled, isolating the specified switch from the fabric.
Recommended Action
Verify that the insistent domain ID is unique in the fabric and then reenable the E_Ports. Run the
fabricShow command to view the domain IDs across the fabric and the configure command to change
the insistent domain ID mode. Refer to the
HP StorageWorks Fabric OS 5.x command reference guide for
more information on these commands.
Severity
ERROR
FABR-1016
Message
Probable Cause
Indicates that FICON mode is enabled on the switch through a user interface command.
Recommended Action
No action is required.
Severity
WARNING
FABR-1017
Message
Probable Cause
Indicates that FICON mode is disabled on the switch through a user interface command.
Recommended Action
No action is required.
Severity
WARNING
FABR-1018
Message
<timestamp>, [FABR-1016], <sequence-number>,, WARNING,
<system-name>, ficonMode is enabled.
<timestamp>, [FABR-1017], <sequence-number>,, WARNING,
<system-name>, ficonMode is disabled.
<timestamp>, [FABR-1018], <sequence-number>,, WARNING,
<system-name>, PSS principal failed (<reason for not becoming the
principal switch>: <WWN of new principal switch>)