HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 145
Severity
WARNING
FABR-1013
Message
Probable Cause
Indicates that there is not enough memory in the switch for the fabric module to allocate. This message is
rare and usually indicates a problem with the Fabric OS.
Recommended Action
The system will recover by failing over to the standby CP.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
CRITICAL
FABR-1014
Message
Probable Cause
Indicates that the specified port received an RDI (request domain ID) accept message containing a
principal-switch-assigned domain ID that is different from the insistent domain ID (IDID). FICON mode
requires an insistent domain ID. If an RDI response has a different domain ID, then the port is disabled.
Recommended Action
Run the configShow command to view the fabric.ididmode. A 0 means the IDID mode is disabled; a 1
means it is enabled.
Set the switch to insistent domain ID mode. This mode is set under the configure command or in Web
Tools on the Switch Admin > configure window.
Severity
ERROR
FABR-1015
Message
<timestamp>, [FABR-1013], <sequence-number>,, CRITICAL,
<system-name>, No Memory: pid=<fabric process id> file=<source file
name> line=<line number within the source file>
<timestamp>, [FABR-1014], <sequence-number>,, ERROR, <system-name>,
Port <port number> Disabled: Insistent Domain ID <Domain ID> could
not be obtained. Principal Assigned Domain ID = <Domain ID>
<timestamp>, [FABR-1015], <sequence-number>,, ERROR, <system-name>,
FICON Insistent DID max retry exceeded: All E-Ports will be
disabled. Switch is isolated.