HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 143
Recommended Action
In case of severe memory corruption, the system might recover by performing an automatic failover.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
FABR-1008
Message
Probable Cause
Indicates that errors occurred during the request domain ID state; the information unit cannot be allocated
or sent. If this message occurs with FABR-1005, the problem is usually transitory. Otherwise, this message
is rare and usually indicates a problem with the Fabric OS. The error descriptions are as follows:
• FAB RDI: cannot allocate IU
• FAB RDI: cannot send IU
Recommended Action
No action is required if the message appears with the FABR_1005 message.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
FABR-1009
Message
Probable Cause
Indicates that errors were reported during the exchange fabric parameter state; cannot allocate domain list
due to a faulty EFP type. This message is rare and usually indicates a problem with the Fabric OS.
Recommended Action
The fabric daemon will discard the EFP. The system will recover through the EFP retrial process.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
<timestamp>, [FABR-1008], <sequence-number>,, WARNING,
<system-name>, <error description>
<timestamp>, [FABR-1009], <sequence-number>,, WARNING,
<system-name>, <error description>