HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

138 Error messages
EM-1055
Message
Probable Cause
Indicates that an incompatible port media is detected.
The possible causes are:
• The port media is not capable of running at the configured port speed.
• The port media generates too much heat to be used in the slot.
Recommended Action
Verify that the media can be run at the configured port speed.
If the port media is extended long wavelength, move it to a port that can support the heat generated.
Severity
WARNING
EM-1056
Message
Probable Cause
Indicates a faulty port media is detected. The reason code for this message is for internal use only. This
message is valid for only the SAN Switch 4/32.
Recommended Action
Replace the defective SFP.
Severity
WARNING
EM-1057
Message
Probable Cause
Indicates the switch is getting an automatic reset. This is usually a transient problem.
Recommended Action
If the message is persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
<timestamp>, [EM-1055], <sequence-number>,, WARNING, <system-name>, <FRU Id>: Port
media incompatible. Reason: <Reason for incompatibility>
<timestamp>, [EM-1056], <sequence-number>,, WARNING, <system-name>, <FRU Id>: Port
faulted. Reason: <Reason code for the fault>
<timestamp>, [EM-1057], <sequence-number>,, WARNING, <system-name>, Blade: <Slot
Id> is getting reset: <fault Reason>