HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

108 Error messages
Probable Cause
Indicates that the switch has completed initializing the ports. This message occurs only on the SAN Switch
4/32.
Recommended Action
No action is required.
Severity
INFO
BL-1002
Message
Probable Cause
Indicates that the blade initiation failed because one or more of the internal ports was not online. The
blade is faulted. This message occurs on only the Core Switch 2/64, SAN Director 2/128, and 4/256
SAN Director.
Recommended Action
Make sure that the blade is seated correctly. If the blade is seated correctly, reboot or power cycle the
blade.
Run the systemVerification command to verify that the blade does not have hardware problems. Refer
to the
HP StorageWorks Fabric OS 5.x command reference guide for more information on this command.
Additional blade fault messages precede and follow this error, providing more information. See other error
messages for recommended action.
If the message persists, replace the blade.
Severity
CRITICAL
BL-1003
Message
Probable Cause
Indicates a faulty blade in the specified slot number. This message occurs on only the Core Switch 2/64,
SAN Director 2/128, and 4/256 SAN Director.
Recommended Action
Make sure that the blade is seated correctly. If the blade is seated correctly, reboot or power cycle the
blade.
Run the systemVerification command to verify that blade does not have hardware problems. Refer to
the
HP StorageWorks Fabric OS 5.x command reference guide for more information on this command.
If the message persists, replace the blade.
<timestamp>, [BL-1002], <sequence-number>,, CRITICAL,
<system-name>, Init Failed: DISABLED because internal ports were
not ONLINE, <slot number> <List of internal ports not ONLINE>
<timestamp>, [BL-1003], <sequence-number>,, CRITICAL,
<system-name>, Faulting blade in slot <slot number>