HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

106 Error messages
Recommended Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
AUTH-1036
Message
Probable Cause
Indicates that the switch received an unexpected authentication message.
Recommended Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
AUTH-1037
Message
Probable Cause
Indicates that a DH-CHAP authentication operation failed on the specified port due to mismatched
response values between two entities.
Recommended Action
The error might indicate that an invalid entity tried to connect to the switch. Check the connection port for
a possible security attack.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
<timestamp>, [AUTH-1036], <sequence-number>,, ERROR, <system-name>,
Invalid state <state value> for <authentication phase>: port <port
number>
<timestamp>, [AUTH-1037], <sequence-number>,, ERROR, <system-name>,
Failed to <operation type> response for <authentication message>:
init_len <data length>, resp_len <data length>, port <port number>.