HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 105
Severity
ERROR
AUTH-1033
Message
Probable Cause
Indicates that an entity was not configured in the SCC policy and tried to connect to the port.
Recommended Action
Add the entity's WWN to the SCC policy and reinitialize authentication by using the portDisable and
portEnable commands or the switchDisable and switchEnable commands.
Severity
ERROR
AUTH-1034
Message
Probable Cause
Indicates that the entity name in the payload is not in the right format.
Recommended Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
AUTH-1035
Message
Probable Cause
Indicates that a particular data field in the authentication message has an invalid length field. This error
usually relates to internal failure.
<timestamp>, [AUTH-1033], <sequence-number>,, ERROR, <system-name>,
Disable port <port number> due to unauthorized switch <switch WWN
value>
<timestamp>, [AUTH-1034], <sequence-number>,, ERROR, <system-name>,
Failed to validate name <entity name> in <authentication message>:
port <port number>
<timestamp>, [AUTH-1035], <sequence-number>,, ERROR, <system-name>,
Invalid <data type> length in <message phase> message: length <data
length>, port <port number>