HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

Fabric OS 5.x diagnostics and system error messages reference guide 103
AUTH-1028
Message
Probable Cause
Indicates that the authentication process failed because the system is low on memory.
Data type is the payload or structure that failed to get memory.
Operation phase specifies which operation of a particular authentication phase failed.
Recommended Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
AUTH-1029
Message
Probable Cause
Indicates that the authentication process failed to get a particular authentication value at certain phase.
Recommended Action
Usually this problem is transient. The authentication might fail.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
AUTH-1030
Message
<timestamp>, [AUTH-1028], <sequence-number>,, ERROR, <system-name>,
Failed to allocate <data type> for <operation phase>: port <port
number>
<timestamp>, [AUTH-1029], <sequence-number>,, ERROR, <system-name>,
Failed to get <data type> for <message phase> message: port <port
number>, retval <error code>
<timestamp>, [AUTH-1030], <sequence-number>,, ERROR, <system-name>,
Invalid message code for <message phase> message: port <port
number>