HP StorageWorks Fabric OS 5.X Diagnostics and System Error Messages Reference Guide (AA-RVHZB-TE, September 2005)

100 Error messages
Recommended Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
AUTH-1018
Message
Probable Cause
Indicates an internal problem with the Secure Fabric OS.
Recommended Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
ERROR
AUTH-1020
Message
Probable Cause
Indicates that an authentication message timer was not created.
Recommended Action
This is transient condition.
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable
and switchEnable commands.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity
WARNING
<timestamp>, [AUTH-1018], <sequence-number>,, ERROR, <system-name>,
Invalid value to check protocol type: port <port number>
<timestamp>, [AUTH-1020], <sequence-number>,, WARNING,
<system-name>, Failed to create timer for authentication: port
<port number>