HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

Fabric OS 5.x command reference guide 789
7 supportShow reference
This chapter explains the information displayed by the supportShow command. This chapter has the
following sections:
• supportShow control commands, page 789
• supportShow command groups, page 789
• Proc entry information displayed, page 792
supportShow control commands
The supportShow command is used to display support information by executing groups of preselected
Fabric OS and Linux commands. The information displayed by the supportShow command can be
controlled by a set of control commands:
supportShow command groups
Table 30 displays the command groups under supportshow, and which Fabric OS or Linux commands
are executed by that group.
NOTE: Many of the commands executed by supportShow are intended for support use only. These
commands are not intended for end users.
supportShowCfgShow Display which groups of commands are enabled to display
under supportShow.
supportShowCfgEnable Enable a group of commands to display under
supportShow.
supportShowCfgDisable Disable a group of commands from displaying under
supportShow.
Table 30 supportShow command groups
Command group Fabric OS 3.2.0 Fabric OS 4.4.0
os mqshow
i
memShow
mallocshow
fastcheckheap
mii-tool –vv
/usr/bin/du -xh / |
/bin/sort:
/bin/ps –elfh
/bin/echo /bin/rpm –qa
/bin/cat
/var/log/dmesg
/bin/cat /etc/fstab
/bin/cat /etc/mtab
printing proc entries.
exception faultshow
traceshow
errDump
errdump –a/-p