HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

740 Fabric OS commands
Displays unicast routing information.
Synopsis
urouteshow [slotnumber/][portnumber][, domainnumber]
Availability
all users
Description
Use this command to display the unicast routing information for a port, as it is known by the FSPF path
selection and routing task. The routing information describes how a frame that is received from a port on
the local switch is to be routed to reach a destination switch.
The following information appears:
The information provided by this command should match what is provided by portRouteShow and
topologyShow.
Operands
This command has the following operands:
uRouteShow
Local Domain ID Domain number of local switch.
In Port Port from which a frame is received. Except for the cases in
which you perform a port swap or enable extended-edge PID
(PID Format 2) on a switch, the value is equal to the Area field
displayed by the switchShow command. See HP
StorageWorks Fabric OS 5.x Fabric Watch administrator’s
guide for more information regarding the extended-edge PID
format.
Domain Destination domain of incoming frame.
Out Port Port to which the incoming frame is to be forwarded. Except for
the cases in which you perform a port swap or enable
extended-edge PID (PID Format 2) on a switch, the value is
equal to the Area field displayed by the switchShow
command. For port swap operations, the value is equal to the
Swport field displayed by the portSwapShow command. See
HP StorageWorks Fabric OS 5.x Fabric Watch administrator’s
guide for more information regarding the extended-edge PID
format.
Metric Cost of reaching the destination domain.
Hops Maximum number of hops required to reach the destination
domain.
Flags Indicates if route is dynamic (D) or static (S). A dynamic route is
discovered automatically by the FSPF path selection protocol. A
static route is assigned using the command uRouteConfig.
Next (Dom, Port) Domain and port number of the next hop. These are the domain
number and the port number of the switch to which Out Port is
connected.
slotnumber For bladed systems only, specify the slot number of the input
port whose routes are displayed, followed by a slash (/).