HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

Fabric OS 5.x command reference guide 671
Saves support information for RASLOG, TRACE, and supportShow.
Synopsis
supportsave [-n] [-c] [-u user_name -p password] -h host_ip -d remote_dir
Availability
admin
Description
Use this command to save RASLOG, TRACE, and supportShow information and other support
information to a remote FTP location. On a dual-CP system, only the local CP information is saved and
supportShow information is not available on the active CP. If no operands are specified, this command
enters interactive mode. The following output files are generated:
Logs are saved in the specified remote directory.
Also, this command reminds you whether or not a new trace dump needs to be generated manually
before you run supportSave.
Operands
The operands are as follows:
supportSave
RASLOG chassisname-slot-YYYYMMDDHHMM-errDumpAll.ss
TRACE chassisname-slot-YYYYMMDDHHMM-tracedump.dmp
supportShow chassisname-slot-YYYYMMDDHHMM-supportShow
Zone log chassisname-slot-YYYYMMDDHHMM-zone.ss
RCS command log chassisname-slot-YYYYMMDDHHMM-rcscmd.ss
NS event log chassisname-slot-YYYYMMDDHHMM-ns.ss
-n Does not prompt you for confirmation. This operand is optional; if omitted,
you are prompted for confirmation.
-c Uses the FTP parameters saved by the command supportFtp. This operand
is optional; if omitted, specify the FTP parameters through command line
options or interactively. To display the current FTP parameters, run
supportFtp (on a dual-CP system, run supportFtp on the active CP).
NOTE: The -c operand is mutually exclusive with -u, -p, -h, and -d.
-u user_name Specifies the user name for the FTP server. This operand is optional; if
omitted, anonymous FTP is used.
-p password Specifies the password for the FTP server. This operand is optional; if omitted,
anonymous FTP is used.
-h host_ip Specifies the IP address for the FTP server.
-d remote_dir Specifies the remote directory for the FTP server.