HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

642 Fabric OS commands
systemGroup configuration parameters
Operands
This command supports the following operands:
--show, --set, and --default support the following:
sysDescr System description. The default value is Fibre Channel Switch.
sysLocation Location of the system (switch). The default value is End User Premise.
sysContact Contact information for this system (switch). The default value is set as Field
Support. See the definition of sysDescr, sysLocation, and sysContact in
system group of MIB-II.
authTraps When enabled, the authentication trap (authenticationFailure) is transmitted to
a configured trap recipient in the event that the agent received a protocol
message that is not properly authenticated. In the context of SNMPv1 and
SNMPv2c, this means that a request contains a community string that is not
known to the agent. The default value for this parameter is 0 (disabled).
--show Displays the SNMP agent configuration data of the specified category.
--set Sets the SNMP agent configuration data of the specified category. This
operand displays the current settings, and then prompts you to change the
values for each parameter.
--default Sets the SNMP agent configuration data for a specified item to the default
values. Generally, these default values might be available in the configuration
database. Factory default settings are set if the SNMP agent configuration
parameters are not available in the configuration database.
snmpv1 Selects SNMPv1-related configuration parameters. SNMPv1 parameters
include the community string, trap recipient IP address, and trap severity level
associated with each trap recipient IP address.
snmpv3 Selects SNMPv3-related configuration parameters. SNMPv3 parameters
include user name, authentication protocol and password, SNMPv3 trap
recipients IP address, associated user index, and trap severity level.
accessControl Selects access-control-related parameters. accessControl parameters include
access host subnet area and access permission (read-write).
mibCapability Selects configuration parameters related to the SNMP agent’s MIBs and trap
capability parameters. mibCapability parameters include MIBs and traps
supported by the SNMP agent.
systemGroup Selects configuration parameters related to the system group. systemGroup
parameters include sysDescr, sysLocation, sysContact, and authentication
failure trap.