HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

640 Fabric OS commands
connUnitEventTrap, and swFabricWatchTrap), are sent to configured trap recipients. By default, this
value is set at 0, implying that no Event Trap is sent. Possible values are:
SNMPv3 configuration parameters
Two user roles, snmpadmin and snmpuser, are supported. snmpadmin provides read-write access and
snmpuser provides read-only access. Entries are added to USM table corresponding to each role. A total
of three entries of role snmpadmin and three entries of role snmpuser are supported. Separate default
passwords are provided for creation of authKey and privKey for each entry. A default set of passwords is
published and a default algorithm (MD5/SHA) is used to create initial set of auth keys. You can change
these passwords using this option. You have the option to select authentication protocol MD5/SHA or no
authentication for each entry.
Select the following combination of protocols:
NoAuth/NoPriv
Auth/NoPriv
Auth/Priv
The length of the user name string should be in range of 2 to 32 characters. Note that the default user
names are defined with the noAuth and noPriv protocol. The factory default SNMPv3 user names are:
User 1: snmpadmin1
User 2: snmpadmin2
User 3: snmpadmin3
User 4: snmpuser1
User 5: snmpuser2
User 6: snmpuser3
The user configuration is available in both the secure and nonsecure mode. When the user selects the
--default option, the user name and passwords are set to default.
In secure mode, the above configuration has to be updated by the user on both primary and nonprimary
switches individually. Unlike community strings, the user name and passwords are not distributed for
other switches in the fabric.
When new passwords are entered for any user entry, new authKey and privKey are generated. The
administrator must update the new passwords on the client (such as a MIB browser) also. AuthKey and
privKey can also be updated using delta key mechanism provided by SNMPv3 protocol.
You are prompted for the password and for re-confirmation of the password, if any protocol is selected
other than NoAuth/NoPriv. The length of protocol passwords should be in range of 1 to 20 characters.
Note that in order for an SNMP management station to receive SNMPv3 traps generated by the agent,
the administrator must configure a trap recipient value to correspond to the IP address of the management
station. Also, the trap recipient should be able to pass the ACL check, as described in ”accessControl
configuration parameters” on page 641. The trap recipient value should be associated with one of the
0None
1Critical
2Error
3 Warning
4Informational
5Debug