HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

Fabric OS 5.x command reference guide 541
Removes a member from a QuickLoop.
Synopsis
qloopremove “qloopName“, “member;member“
Availability
admin
NOTE: This command requires HP Advanced Zoning license, which is included within the Base
Configuration Services and bundled with each B-series switch.
Description
Use this command to remove one or more members from a QuickLoop.
The member list is identified through an exact string match; therefore, when removing multiple members,
order is important. For example, if a QuickLoop contains “wwn3; wwn4”, removing “wwn3; wwn4”
succeeds, but removing “wwn4; wwn3” fails.
If all members are removed, the QuickLoop is deleted.
When a configuration is enabled, all QuickLoops defined in the configuration must resolve to one or two
switch worldwide names.
This command changes the Defined Configuration. For the change to be preserved across switch reboots,
it must be saved to non-volatile memory using the cfgSave command. For the change to become
effective, an appropriate zone configuration must be enabled using the cfgEnable command.
NOTE: When security is enabled, this command can be issued only from the primary FCS switch.
Use this command only with Fabric OS 3.x systems in the fabric; QuickLoop is not supported in Fabric
OS 5.x.
Operands
The following operands are required:
Examples
To remove member “wwn2” from “qlp1”:
qloopRemove
qloopName Specify the name of the QuickLoop, in quotation marks.
member Specify the list of the QuickLoop members to be removed, in
quotation marks, separated by semicolons. Include one or more
of the following:
• world wide names
• Zone alias names
switch:admin> qloopRemove "qlp1", "wwn2"