HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

Fabric OS 5.x command reference guide 493
Codes used in various fields are as follows:
ctin Argument 0 is divided into two 16-bit fields:
[A] A bit map indicating whether subsequent args
are valid (0001 means argument 1 is valid,
0003 means arguments 1 and 2 are valid)
Argument 1 is the first word of the CT payload, if
applicable (as specified in [A])
Argument 2 is the second word of the CT
payload, if applicable (as specified in [A]).
[B] The CT-based service command code
ctout Argument 0 is also divided into two 16-bit fields:
[A] A bit map indicating whether subsequent args
are valid (0001 means argument 1 is valid,
0003 means arguments 1 and 2 are valid).
[B] The CT command code indicating whether an
accept (8002) or a reject (8001).
If [B] is an accept, argument 1 and 2 represents
the first and second words of the CT payload, if
applicable (as specified in [A]).
If [B] is a reject, argument 1 contains the CT
reject reason and explanation code.
errlog Error type (see errModuleShow)
loopscn The meaning further depends on each loop state:
OLP Offline reason code, usually zero
LIP Reason code for LIPs initiated by FL_Port, if the code value is
800x (x = [1,0xc], see below), or the lower two bytes of the
LIP received, if the code value is other than 800x
LIM Usually zero
BMP Memory address for the loop bitmap
OLD Usually zero
TMO Encoded value of the state when loop init timed out This
value is usually equal to the first word of a loop init frame
payload. Other possible values include:
2 LIP (req. INITIALIZING) timeout
94F0F0 ARB(F0) timeout
40 CLS timeout
state 1 Online
2Offline
3Testing
4Faulty
5 E_Port
6 F_Port
7Segmented
pstate AC Active State
LR1 Link Reset: LR Transmit State
LR2 Link Reset: LR Receive State
LR3 Link Reset: LRR Receive State