HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

Fabric OS 5.x command reference guide 475
Cycles user port LEDs.
Synopsis
portledtest [-npass count][-ports itemlist]
Availability
admin
Description
Use this command to exercise the user port LEDs in the current switch on and off by setting the ATTN LEDs
to green for the ON condition and unlighted for the OFF condition. The SPEED LEDs are initially set to
black before the command execution. The SPEED LEDs are set to green once the command is executing.
You must disable the current switch (using the switchDisable command) before running this
command. After the command had completed, the ATTN LEDs flash amber, indicating that the command
has finished and exited. You can enable the current switch (using the switchEnable command) to set
the ATTN LEDs back to black.
Operands
This command has the following optional operands:
Examples
To test port LEDs:
See also
itemList
switchDisable
switchEnable
portLedTest
-npass count Specify the number of times to perform this test. The default value
is 10.
-ports itemlist Specify a list of user ports to run the test. If omitted, all the active
ports in the switch are assumed. For more information, see the
itemList command.
switch:admin> portledtest -ports 1/1-1/5
passed.