HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

Fabric OS 5.x command reference guide 467
Configures a port to be enabled or disabled for HP ISL Trunking license.
Synopsis
portcfgtrunkport [slotnumber/]portnumber mode
Availability
admin
NOTE: This command requires a ISL Trunking license.
Description
Use this command to enable or disable a port for trunking.
NOTE: You can disable or enable trunking using the portCfgTrunkPort or switchCfgTrunk
commands. When the command is executed to update the trunking configuration, the ports for which the
configuration applies are disabled and reenabled with the new trunk configuration. As a result, the traffic
through these ports might be disrupted for a period of time.
Operands
This command has the following operands:
Examples
To enable a port for trunking:
See also
portCfgShow
portShow
switchCfgTrunk
switchShow
portCfgTrunkPort
slotnumber For bladed systems only, specify the slot number of the port to
be configured, followed by a slash (/).
portnumber Specify a port number to be configured, relative to its slot for
bladed systems. Use switchShow to display a list of valid
ports.
mode Specify 1 to enable this port for trunking. Specify 0 to disable
this port for trunking. This operand is required.
switch:admin> portcfgtrunkport 1/3 0