HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

456 Fabric OS commands
Locks a port as an L_Port.
Synopsis
portcfglport [slotnumber/]portnumber locked_mode [private_mode]
[duplex_mode]
Availability
admin
Description
Use this command to designate a port as an L_Port. The switch then only attempts to initialize that port as
an FL_Port. By default, the L_Port is a public L_Port. It can be set to private L_Port and the FLOGI is
rejected.
The switch never attempts point-to-point (F_Port) initialization on the port.
Operands
The operands are as follows:
If used without operands, this command reports the L_Port conditions for all ports present.
portCfgLPort
slotnumber For bladed systems only, specify the slot number of the port to
be configured, followed by a slash (/).
portnumber Specify a port number to be configured, relative to its slot for
bladed systems. Use switchShow to display a list of valid
ports. This operand is optional; if omitted, this command
displays the L_Port conditions for all ports.
locked_mode Specify 1 to configure the specified port as a locked L_Port.
Specify 0 to deconfigure the specified port from its previous role
as a locked L_Port. This operand is required if portnumber is
specified.
private_mode Specify 1 to configure the L_Port as a private L_Port. Specify 0
to configure the L_Port as a normal public L_Port. This operand
is optional; if omitted; the default value of 0 is used. Private
devices are supported only on HP StorageWorks SAN Switch
2/8V, 2/16V, 2/32 switches and HP StorageWorks Core
Switch 2/64, and HP StorageWorks SAN Director 2/128 and
4/256 directors with SAN Switch 2/16 blades. For other
switches and blade types, option 1 is blocked.
duplex_mode Specify 2 to configure the specified port as a full-duplex L_Port
with fairness. Specify 1 to configure the L_Port as a half-duplex
L_Port with fairness. Specify 0 to configure the L_Port as a
full-duplex L_Port. This operand is optional; if omitted, the
default value of 0 is used.