HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

444 Fabric OS commands
Sets a port's configuration to be disabled or enabled.
Synopsis
portCfg action [slotnumber/]portnumber [range] mode
Availability
admin
Description
Use this command to disable or enable configuration to a certain port or to a range of ports.
Operands
This command has the following operands:
portCfg
action Possible action includes rscnsupr. rscnsupr is for the local port's
RSCN suppression. When RSCN suppression is enabled to a port,
any device change on this port does not generate RSCN to any other
end device. When RSCN suppression is disabled, device change on
this port generates RSCN to another end device that is zoned with this
one. By default, RSCN suppression is disabled to all the ports.
slotnumber For bladed systems only, specify the slot number of the port to be
configured, followed by a slash (/).
portnumber Specify the number of the ports to be configured, relative to its slot for
bladed systems. Use switchShow for a list of valid ports.
range Specify a range of port in the same slot to apply the configuration. The
range of ports has to be equal to or greater than the portnumber.
mode Specify --enable to enable the configuration. Specify --disable
to disable the configuration.