HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

382 Fabric OS commands
Displays the information of all the online devices zoned with the given device.
Synopsis
nszonemember -a | -u | pid | wwn
Availability
all users
Description
Use this command to display information about all the online devices zoned with the given device.
Issuing this command without operands displays all online devices zoned with the given device. Each line
of output displays:
There might be additional lines if the device has registered any of the following information (the switch
automatically registers SCSI inquiry data for FCP target devices):
• FC4 supported
• IP address (node)
• IPA
• port and node symbolic name (local device only)
• fabric port name
• hard address and/or port IP address
Operands
This command has the following operands:
nsZoneMember
Type U for unknown, N for N_Port, NL for NL_Port
Pid The 24-bit Fibre Channel address
COS A list of classes of service supported by the device
PortName The device's port world wide name (WWN)
NodeName The device's node WWN
Permanent Port
Name
Physical N_Port or NL_Port WWN
DeviceType The device’s type
-a Displays each local device’s online zoned device data, including the PID
and zone alias.
-u Displays all the unzoned devices in the entire fabric. The device data
displayed includes the device PID and zone alias.
pid | wwn Specifies the port ID or WWN, respectively, whose zoned devices are to
be viewed. This operand is required.