HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

250 Fabric OS commands
Operands
This command has the following optional operands:
Examples
To run fportTest on a switch:
Diagnostics
The following are possible error messages if failures are detected:
DATA
INIT
PORT_DIED
EPI1_STATUS_ERR
ERR_STAT
ERR_STATS
ERR_STATS_2LONG
ERR_STATS_BADEOF
ERR_STATS_BADOS
ERR_STATS_C3DISC
ERR_STATS_CRC
ERR_STATS_ENCIN
ERR_STATS_ENCOUT
ERR_STATS_TRUNC
ERR_STAT_2LONG
ERR_STAT_BADEOF
-nframes count Specify the number of times (or number of frames per port) to execute
this test. If count is omitted, the default of 10 is used.
-ports itemlist Specify the ports to test. If itemlist is omitted, the test is executed on
all online F_Ports in the specified slot.
-seed payload_pattern Specify the pattern of the test packets payload. Valid values are:
0CSPAT (default)
1BYTE_LFST
2 CHALF_SQ
3QUAD_NOT
4CQRT_SQ
5CRPAT
6RANDOM
-width pattern_width Specify the width of the pattern. Valid values are:
1byte
2word
4quad
-size pattern_size Specify the number of words in the test packet payload. If
pattern_size is omitted, the default value is 512.
switch:admin> fporttest -ports 1/0-1/15
Running fPortTest .......
Test Complete: "fporttest" Pass 10 of 10
Duration 0 hr, 0 min & 1 sec (0:0:0:127).
passed.