HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

238 Fabric OS commands
NOTE: This command is not supported on the HP StorageWorks 4/8 or 4/16 SAN switch, the HP
StorageWorks SAN Switch 4/32, or the HP StorageWorks 4/256 SAN Director, which use the Condor
ASIC.
Operands
This command has the following operands:
Examples
To run a frame filter test:
Diagnostics
When it detects failures, the subtest might report one or more of the following error messages:
DIAG-ACTTEST
DIAG-FLTINIT
DIAG-FLTRCV
DIAG-FLTXMIT
DIAG-NUMTEST
See the HP StorageWorks Fabric OS 5.x diagnostics and system error messages reference guide for more
information.
See also
itemList
--slot slotnumber Specify the slot number on which the diagnostic operates. The
port specified are relative to this slot number. The default is 0
and designed to operate on fixed-port-count products.
-passcnt passcnt Specify the number of times to perform this test. The default value
is 1.
-txports itemlist Specify the user port numbers to perform this test. All user ports
are set by default.
-scamoff offset Specify the program location to write SCAM test data in SCAM
memory. The default value is 0. The maximum offset number is
set if the specified number is larger than the limit.
-dcamoff offset Specify the program location to write DCAM test data in DCAM
memory. The default value is 0. The maximum offset number is
set if the specified number is larger than the limit.
-fdefoff offset Specify the program location to write filter test definition data in
filter definition memory. The default value is 0. The maximum
offset number is set if the specified number is larger than the
limit.
switch:admin> filtertest -txports 3/1-3/3
Running filtertest ..............
Test Complete: filtertest Pass 1 of 1
Duration 0 hr, 0 min & 2 sec (0:0:2:679).
passed.