HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

220 Fabric OS commands
Display the Fibre Channel Protocol (FCP) Read Link Status (RLS) information.
Synopsis
fcprlsshow [slotnumber/]portnumber
Availability
all users
Description
Use this command to display the FCP RLS information for a particular device, which should be either an
F_Port or FL_Port. This information describes the number of loss-of-signal, loss-of-sync, CRC-error, and
other failure events that have been detected on this port.
Operands
This command has the following operands:
Examples
To display the FCP RLS information:
See also
portLoginShow
portLogShow
fcpRlsShow
slotnumber For bladed systems only, specify the slot number of the port to
display, followed by a slash (/).
portnumber Specify the port number to display, relative to its slot for bladed
systems. Use switchShow to list valid ports. This operand is
required.
switch:admin> fcprlsshow 2/5
link fail loss sync loss sig prtc err bad word crc err
0xda 0 5 0 0 525 0
0xdc 0 3 0 0 330 0