HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

Fabric OS 5.x command reference guide 199
Enables a fan unit.
Synopsis
fanenable unit
Availability
admin
Description
Use this command to return the fan unit to the default RPM speed (only if the fan unit has been previously
disabled using the fanDisable command).
NOTE: This command is not available on nonbladed systems except for the StorageWorks SAN
Switch 4/32.
Operands
This command has the following operand:
Examples
To enable a fan unit:
See also
fanDisable
fanShow
fanEnable
unit Specify the fan's unit number to enable. View the fan unit
numbers using the fanShow command. This operand is
required.
switch:admin> fanenable 1
Fan unit 1 has been enabled