HP StorageWorks Fabric OS 5.X Command Reference Guide (AA-RVHVB-TE, September 2005)

172 Fabric OS commands
Sets a filter for an error log destination.
Synopsis
errFilterSet [-d “destination“][-v “severity“]
Availability
admin
Description
Use this command to set a filter for an error log destination. A filter is set based on the severity level of the
messages.
If no parameters are specified, this command displays the filters that are currently in use.
Operands
This command has the following operands:
Examples
To display the current filter settings:
To set the filter severity level for the console:
See also
errDump
errModuleShow
errFilterSet
-d “destination“ Specifies the destination to set the filter. The “console“ string is
the only valid value at this time.
-v “severity“ Specifies the minimum severity of the message to pass through
the filter. Valid values are “INFO“, “WARNING“, “ERROR“, and
“CRITICAL“.
switch:admin> errfilterset
console: filter severity = WARNING
switch:admin> errfilterset -d "console" -v "WARNING"