HP StorageWorks Fabric OS 5.x Advanced Web Tools Administrator Guide (AA-RVHXB-TE, September 2005)

42 Managing your fabrics, switches, and ports
Figure 9 Configure tab, Fabric subtab
Configuring fabric parameters
1. Launch the Switch Admin module as described on page 36.
2. Disable the switch as described in ”Enabling and disabling a switch” on page 39.
3. Click the Configure tab.
4. Click the Fabric subtab.
5. Make the fabric parameter configuration changes.
6. Click Apply.
7. Enable the switch as described in ”Enabling and disabling a switch” on page 39.
Enabling insistent domain ID mode (FICON only)
When insistent domain ID (ID_ID) mode is enabled, the current domain setting for the switch is insistent;
that is, the same ID is requested during switch reboots, power cycles, CP failovers, firmware downloads,
and fabric reconfigurations. If the fabric does not assign the insistent domain ID, the switch segments from
the fabric.
This parameter is for use with FICON only.
1. Launch the Switch Admin module as described on page 36.
2. Disable the switch as described in ”Enabling and disabling a switch” on page 39.
3. Click the Configure tab.
4. Click the Fabric subtab.
5. Check the Insistent Domain ID Mode check box.
6. Click Apply.
7. Enable the switch as described in ”Enabling and disabling a switch” on page 39.