HP StorageWorks Fabric OS 5.0.5b Release Notes (AA-RW1WD-TE, December 2006)

Brocade 4Gb SAN Switch for HP p-Class BladeSystem chassis
Early versions of the 4Gb SAN Switch for HP p-Class BladeSystem units have the potential
to interfere with a Cisco GbE3 switch being removed or installed into the adjacent slot.
Obtaining a PKI Certificate for Secure Fabric OS
For information on activating Secure Fabric OS go to the following HP web s ite:
h
ttp://www.hp.com/storage/go/ secureos
Also, you may refer to the Secure Fabric OS Administrator’s Guide,Chapter2,
“Preparing the Fabric for Secure Fabric OS,” for specific pro cedures.
Non-default ope
rands
The use of non-default operands for diagnostic commands is recommended for advanced
users and field support only.
Need to turn traps on manually
The SilkWorm and FA traps in pre-Fabric OS 4.4.0 code were turned on and off as a
group; and it wasn’t possible to set individual SilkWorm or FA traps. In 4.4.0 the ability
to turn traps on and off individually was added. That means, that individual traps need
to be turned on explicitly af ter the corresponding trap group is turned on.
After the upgrade from Fabric OS 4.2.0 firmware, individual traps are turned off by
default even if the corresponding trap group was turned on before the upgrade.
Therefore if you have been previously monitoring these traps, you need to use either
snmpMibCapSet or the newer snmpconfig command to turn the desired traps on
individually.
The default setting is for all traps is Disabled.
Save the z
one database configuration immediately after an upgrade
When considering an upgrade to a later Fabric OS release the user should save the
zone database configuration immediately following the upgrade. Changes to the zoning
database can then be conducted. If you are considering downgrading to the prior
Fabric OS release, remember to clear the zoning database then restore the saved zoning
database configuration prior to the downgrade.
Zoning
With AUDIT logging enabled, while performing zoning changes via CLI, an additional
audit log from HTTP may also appear along with the audit logs from zoning. This
Fabric OS 5.0.5b
9