HP StorageWorks Core Switch 2/64 Getting Started & General Reference Guide

42 getting started and general reference guide
Note To ensure a current configuration is available for uploading to a
replacement switch, a routine backup of the configuration is recommended.
Use the
cfgSave and cfgEnable commands to save any zone
configurations before the switch is powered off. The saved configuration is
automatically reloaded by the switch on power up. If a configuration was
enabled at the time it was saved, the same configuration is reinstalled with
an automatic cfgEnable command.
Saving the System Configuration Files
Upload the switch configuration file for disaster recovery and keep it in a
safe place where it can be easily found. Backing up the configuration after
the initial configuration changes is strongly recommended. A routine
backup of the configuration is also recommended to ensure the current
configuration is available if needed.
Backing up the Switch Configuration Settings
Use File Transfer Protocol (FTP) on Windows or UNIX workstations to
backup the system configuration. The FTP server must be running before
an upload can occur.
1. Verify that the FTP service is running on the host workstation.
2. Log in to the switch as the admin user.
3. At the command line enter the following command:
configUpload "hostIPaddr", "user",
"path_filename","password"
where hostIPaddr is the IP address of the host computer, user is the
User ID used to log into this computer,
path_filename is the path