HP StorageWorks Core Switch 2/64 Getting Started & General Reference Guide

36 getting started and general reference guide
– For most UNIX systems, enter the following string at the prompt:
tip /dev/ttyb -9600
e. When the terminal emulator application stops reporting information,
press Enter to get the following login prompt:
CP0 Console Login:
f. Enter the administrative login information. The default administrative
login is
admin and the default password is password.
Note At the initial login, the user is prompted to enter new Admin and
User passwords. The same administrative account applies to both logical
switches and both CP cards. If the password is changed on a logical switch
or CP card, it is automatically changed for both logical switches and both
CP cards.
Note Passwords must be a total of 8 to 40 characters long, and should
include a combination of numbers and upper case and lower case letters. To
skip modifying the password, press CTRL+C.
g. Enter “0” at the following prompt to log in to switch 0:
Enter switch number to login <0 or 1>: 0
3. Enter the following command to determine which CP card is active:
haShow
This command provides information:
switch:admin> haShow
Local CP (Slot 5, CP0): Active
Remote CP (Slot 6, CP1): Standby
HA Enabled, Heartbeat Up
For more information about this command, refer to the hp StorageWorks
fabric os reference.
4. Configure the IP address information for both CP cards by completing
the following steps: