HP StorageWorks Core Switch 2/64 Getting Started & General Reference Guide

Starting and Configuring the Switch 31
3
STARTING AND CONFIGURING THE
SWITCH
Providing Initial Power to the Switch
1. Connect the AC power cord retainer to the chassis:
Figure 19. Power Cord Retainer
a. Orient one of the retainers as shown in Figure 19.
b. Position the retainer tabs under the two screws on either side of a power
connector on the chassis. Tighten both screws.
c. Loosen the adjusting screw to allow the power cord to fit into the
retainer.
d. Repeat Step 1 for the other retainer.
2. Connect the power cords to the power connectors on the HP StorageWorks
Core Switch 2/64 by inserting them through the retainers. Ensure the
power cord has a minimum service loop of six inches available at the
connection to the switch, and is routed so that it is not exposed to stress.
Adjusting Screw
Chassis
Screw