HP StorageWorks Core Switch 2/64 Getting Started & General Reference Guide

24 getting started and general reference guide
9. Slide the switch from the pallet onto the lift and then position the lift at
the front of the rack. Note that the port side of the switch will go in first
and will face out of the rear of the rack. The blower side will face out of
the front of the rack (see Figure 14). Due to the weight of the switch,
moving the switch requires two or three people.
Figure 14. Placing the Switch on the Lift
10.Slide the switch onto the rack until the switch is six inches beyond the
rear of the rack. Because the switch is front (port side) heavy, do not slide
the switch more than six inches beyond the rear of the rack to prevent it
from tipping off the rack.
Blower Assembly
Side of the Switch
Rear of Rack
Front of Rack