HP StorageWorks Core Switch 2/64 Getting Started & General Reference Guide

Installing the Switch 21
e. Install each rail assembly to the inside of the rack columns with six
screws per rail assembly, two on the front of the rack and four on the
rear of the rack (see Figure 11). For an HP Rosebowl II rack, use
1/4-20 x .5” Phillips pan-head screws. For a Compaq/Rittal rack, use
1/4-20 x .5” Phillips pan-head screws with a .375” square mounting
hole between the screw and the rack column.
Figure 11. Installing the Rail Assembly
f. Tighten each of the adjusting screws loosened earlier.
Compaq/Rittal
Rack
1/4-20 Phillips
.375” Square
Rail Assemblies (2x)
Adjusting Screws
1/4-20 Phillips
Pan-Head
Screws (6x set)
HP Rosebowl II Rack
Pan-Head
Screws (6x set)
Mounting Hole
(6x set)
Rear of Rack
Front of Rack