HP StorageWorks Core Switch 2/64 Getting Started & General Reference Guide

16 getting started and general reference guide
4. Remove the following items from the chassis:
Note Complete the following steps before attempting to slide the switch
onto the rack. The switch may not be installed from the front of the rack if
you do not first remove the front door, door hinges, and front mounting
brackets. Removal of the door hinges and front mounting brackets (steps 4b
and 4c) is not required if the switch can be installed from the rear of the
rack. Removal of the door (step 4a) is always recommended.
a. Remove the front door by pressing the spring-loaded pins (see
Figure 6).
Figure 6. Removing the Front Door
Upper Door Hinge Upper Door Hinge with Lever
Out of Notch (Pin Released)with Lever In Notch
Chassis Portion of Hinge