HP StorageWorks Core Switch 2/64 Getting Started & General Reference Guide

Installing the Switch 13

Hardware Identification

Table 2 contains drawings and descriptions of the hardware used when

installing the HP StorageWorks Core Switch 2/64 in an HP Rosebowl II or

Compaq/Rittal rack. Use this table to help identify the hardware specified

in the installation procedure in this chapter.

Note Depending on the rack you use, you may not be using all of the

hardware listed below.

Installing the Switch in a Rack

Figure 4 shows the switch already installed in a rack. The rest of this

section provides instructions for installing the HP StorageWorks Core

Switch 2/64 in an HP Rosebowl II or Compaq/Rittal rack.

Table 2. Hardware Key

#10-32 x .63” Phillips pan-head screws with integrated lock

washers (4)

1/4-20 x .5” Phillips pan-head screws (16)

1/4-20 x .5” Phillips pan-head screws with integrated lock

washers (16)

#10-32 x 1/4” flat-head screws (8)

#8-32 x 1/4” flat-head screws (8)

.375” square mounting holes (16)

#10-32 square Tinnerman nuts (4)

M5 Torx head screws with captive lock washers (4)

M5 U-type Tinnerman nuts (4)