HP StorageWorks Core Switch 2/64 Getting Started & General Reference Guide

12 getting started and general reference guide
Note HP recommends the use of two separate power distribution units
(PDUs) with the switch. Each PDU must have at least one C19 connector.
Purchase the PDUs separately. For more information, see “Power
Specifications” on page 71.
Tools Required
The following tools are required to install the switch in a rack:
• #2 Phillips and T25 Torx screwdrivers.
• 1/2-inch socket wrench to remove the pallet bolts.
• A lift capable of lifting a minimum of 250 pounds.
– Recommended Lift: LIFT-O-FLEX®
17000 SP 400 from R on I. For
more information, visit their Web site at
http://www.roni.com/.
B Rear mounting brackets
C Rail assemblies
Other items not shown:
• hp StorageWorks Core Switch 2/64 Documentation CD
• hp StorageWorks Fabric Manager CD
• Two power cord retainers
• One 10 foot RS-232 serial cable, convertible to an RJ-45 cable
by removing the adapter on the end of the cable
• Two jumper cables that allow switch to PDU connections
• Cable guides
• Hardware used to install the switch in a rack
Table 1. Contents of the Shipping Carton(s)