HP StorageWorks Audit Log reference guide (5697-5923, June 2006)

Audit Log Reference Guide 269
Note 3
When you perform two or more LUN Manager operations, the following conditions apply:
• When you perform two or more operations on one target and select Apply, the log
information is output as one entry.
• When you apply two or more settings at one time, the log information is output according to
the priority shown in Table 189.
Table 189 LUN Manager Operation and Priority of Audit Log Output
If the priority is the same, the log information is output in the order of the operations performed.
If you perform the following operations at the same time, the following happens:
• Add → Delete: The operations cancel each other and no log information is output.
• Change → Delete: Log information is output for the Delete operation.
• Change 1 → Change 2: Log information is output for the Change 2 operation.
• Add → Change: Log information is output as an Add operation, but the contents of the
setting are output according to the setting of the Change operation.
If you have deleted a host group, the following operations performed for that Host Group are not
output as log information:
• Changing host mode
Operation Target of Operation Priority
Delete LU 2
Host Group 1
WWN 1
DKC connection WWN 2
Add LU 4
Host Group 3
WWN 3
Change Host Group 3
WWN 3
Changing Host Mode 3
Command Device 4
Command Dev. Security 4
LUN Security OFF: 3
ON: 1