Hitachi Universal Replicator (TM) for Mainframe User Guide: HP XP24000 Disk Array, HP XP20000 Disk Array (T5278-96044, May 2011)

Before Using Spreadsheets
Remote Web Console is required for spreadsheets. Perform the following operations in Remote
Web Console before using spreadsheets in Universal Replicator for Mainframe:
• Create master journal groups (see “Reviewing Administrator Tasks for Managing Journals”
(page 162))
• Register the secondary storage system (see “Setup Procedure (When More Than One Primary
and Secondary Storage System are Used)” (page 144))
• Create remote journal groups (see “Reviewing Administrator Tasks for Managing Journals”
(page 162))
For detailed information about how to perform these operations in the Remote Web Console, see
“Configuring Storage Systems and Logical Paths” (page 142) and “Configuring Journal Groups”
(page 162).
#!Version Version number, program product, type,;
[Operation tag]
Parameters
Italics in the example above indicate variables that depend on the program product or operation.
The table below illustrates how to format these variables.
Table 41 Formatting the Spreadsheet Content
Content (format)Element
05_02_01Version number
1
CLI_RemoteCopyJournalMFProgram product
See “Available Types and Operation Tags” (page 213)Type
Operation tag
See “Getting Pair Information (Pair Tag)” (page 214)
and the following sections.
Parameter
1 The version number may depend on the type of operations.
Available Types and Operation Tags
Available operation tags for Universal Replicator for Mainframe depend on the types. The following
table shows the relationship between types and operation tags supported by Universal Replicator
for Mainframe.
Table 42 Relationship Between the Types and Operation Tags
Default FileOperation TagType
RemoteCopyJournalMF_Get_def_.spdPairGet
RemoteCopyJournalMF_AddPair_def_.spdAddPairPairOperation
RemoteCopyJournalMF_SuspendPair_def_.spdSuspendPair
RemoteCopyJournalMF_ResumePair_def_.spdResumePair
RemoteCopyJournalMF_DeletePair_def_.spdDeletePair
If the type is PairOperation, write only one operation tag on each spreadsheet.
For detailed information about the parameters for each operation tag or the output, see the following
sections.
Before Using Spreadsheets 213