HP StorageWorks XP24000 Continuous Access Software User and Reference Guide, v01 (T5278-96002, June 2007)

Figure 30 Add

SSID Dialog Box

To add one or more SSIDs to an existing RCU:

1. Click the RCU Operation tab, and click the MCU&RCU display button.

2. Select and double-click on the desired MCU CU in the tree, and then select the RCU to which

you want to add SSID(s). Alternatively, select the RCU in the list, right-click, and click Edit SSID(s)

&Path(s). All SSIDs for the selected RCU are listed.

3. Right-click the path/SSID list, and then click Add SSID to open the Add SSID dialog box.

4. On the Add SSID dialog box, enter the new SSID(s).

5. Click Set to close the Add SSID dialog b ox. The preview list displays the requested add SSID

operation(s) .

6. Verify the requested operation(s) displayed in the preview list.

To change an add SSID operation, select the operation from the preview list, right-click, and

click Modify. To remove an op eration, select the operation, right-click, and click Delete.To

cancel

all operations, select all the operations in the preview list, right-click, and click the De l ete

command, or click the Cancel button.

7. To start the operation(s), click the Apply button.

Before deleting an SSID, make sure that all affected Continuous Access pairs (pairs having S-VOLs in the

RCU SSID to be deleted) h ave already been released. If all affected pairs have not be en released, the

MCU

will reject the delete SSID operation to prevent an accidental release of Continuous Access pairs.

The Del ete SSID command allows you to delete an SSID from an existing RCU.

To delete an SSID from an existing RCU:

1. Click the RCU Operation tab, and click the MCU&RCU display button.

2. Select and double-click on the desired MCU CU in the tree, and then select the RCU for which

you want to delete an SSID. Alternatively, select the RCU in the list, right-click, a nd click Edit

SSID(s) & Pat h (s). All SSIDs for the selected RCU are listed.

3. Right-click the path/SSID list, and then click Delete SSID.Whenaconﬁrmation message

appears, click OK to delete the S SID, or click Cancel to cancel your request to delete the SSID.

The preview list displays the requested delete SSID operation(s). Delete is displayed in the

right-most column of the selected SSID in the path/SSID list.

4. Verify the requested o perations displayed in the preview list.

To remove an op eration, select the operation from the preview list, right-click, a nd click Delete.

To cancel all operations, select all the operations in the preview list, right-click, a nd click the

Delete command, or click the Cancel button.

5. To start the operation(s), click the Apply button.

Viewing RCU Status

The RCU Status dialog box (see Figure 31 on page 8 1) displays the detailed status information

for the selected RCU. Table 19 on page 82 describes the path status descriptions. See

“General Troubleshooting” on page 135 for troubleshooting information for MCU-RCU paths.

Performing Continuous Access Conﬁguration Operations