HP StorageWorks XP24000 Continuous Access Software User and Reference Guide, v01 (T5278-96002, June 2007)

To cancel all operations, select all the operations in the preview list, right-click, a nd click the

Delete command, or click the Cancel button.

5. To apply the settings, click the Apply button.

Adding and Deleting Logical Pa ths to an RCU

Before ad ding a path to an RCU, make sure that the remote copy connection is properly installed, the

appropriate MCU ports are conﬁgured as initiator por ts, and the appropriate MCU CU is selected.

You can add up to four RCUs to each MCU CU and establish up to eight paths to each RCU. When

you add a path to an RCU, Continuous Access will automatically start using the new path to perform

Continuous Access copy activities.

The Add P ath d

ialog box (see Figure 29 on page 78) allows you to add one or more paths to an

existing RCU. To open the Add Path dialog box, select the MCU&RCU display on the RCU Operation

window, select and double-click on the desired MCU CU in the tree, select the desired RCU, and then

click the Ad

dPath command.

Figure 29 Add Path Dialog Bo x

MCU Port: Allows you to select the MCU port number from the drop-down list or to enter the port number

directly. Initiator ports are listed.

RCU Por

t: Allows you to select the RCU port number from the drop-down list or to enter the port num ber

directly. You must select an RCU target port.

Note:

The number of enabled ﬁelds indicates the number of paths that can be added.

Note:

You can specify the port number with two characters. For instance, you can abbreviate CL1-A as

1A.You

can also enter the port number in both lowercase and uppercase characters.

To add one or m ore new logical paths from the connected MCU to a n existing RCU:

1. Click the RCU Operation tab, and click the MCU&RCU display button.

2. Selec

and double-click on the desired MCU CU in the tree, and select the RCU to which you

want to a dd one or more paths. Alternatively, select the RCU in the list, right-click, and click

Edit

SSID(s) & Path(s). All paths to the selected RCU are listed.

3. Right

-click the pa th and SSID list, and click Add Path to open the Add Path dialog box.

4. On the Add Path dialog box, enter the new path(s).

Performing Continuous Access Conﬁguration Operations