HP StorageWorks XP24000 Continuous Access Journal Software User and Reference Guide, v01 (T5278-96001, June 2007)

4. Locate mirrors that are in Stop status.
5. From the mirrors, select and right-click the mirror(s) that you want to restore.
When
you select the mirror in Stop status, the copying of data will be restarted after the recovery.
6. From the pop-up menu, select JNL Groups and Pairresync.
7. See the Preview list to check the mirrors that you want to restore.
• To cancel restoring a mirror, select and right-click the mirror and then select Cancel.
• If necessary, you can repeat steps 3 to 7 to specify other mirrors.
8. Select Apply to restore the mirror(s).
Note : If an error occurs, the right-most column of the Preview list displays the error code. To
vie w detailed information about the error, right-click the error code and then select Error Detail.
An error message appears a nd gives you detailed information about the error.
Deleting Data Volumes from a Mirror (Pairsplit-S: Ending a
Copy Operation)
A mirror is a combination of a master journal group and a restore journal group. If you delete data
volumes from a mirror, the copying of d ata from the master journal group to the restore journal group
will end.
To delete da
ta volumes from a mirror, follow the procedure below. Not only the primary storage system
administr
ator but
also the secondar y storage system administrator can perform this operation.
1. Ensure th
at the
Remote Web Console m ain window is in Modif y m ode.
F or detailed information about how to do this, see HP StorageWorks XP24000 Remote Web
Console User’s Guide.
2. Ensure th
at the
Journal Operation window is displayed (see
“Journal Operation Window” on page 77) .
3. Do either of the following:
• In the tree, select a ma ster journal g roup (
) or a restore journal group ( )from below
Registe
red.
• In the tree, select Journal G roups or Registered and then select a master journal group (
)or
a
restore journal group ( )from the list to theright.
The list displays a list of mirrors. One row in the list represents one mirror.
4. Locate mirrors that are not in Initial status.
5. From the mirrors, select and right-click the mirror(s) from which you want to delete da ta volumes.
6. From the pop-up menu, select JNL G roups and Pairsplit-S.
7. See the Preview list to check the settings that you have made.
• To cancel a setting, select and right-click the setting and then select Cancel.
• If necessary, you can repeat steps 3 to 7 to specify other mirrors.
8. Select Apply to delete data volumes from the mirror(s).
Note : If an error occurs, the right-most column of the Preview list displays the error code. To
vie w detailed information about the error, right-click the error code and then select Error Detail.
An error message appears a nd gives you detailed information about the error.
124
Using
Journal Groups