HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

Using the Graphical User Interface 83
Using the Graphical User
Interface
Running the Management GUI Directly from a Web Browser
If you know the ID of the specific array you want to manage, you can run the
management GUI directly from the browser.
1 Open a browser on the client.
2 Type the following URL into the address field in the browser:
http://<hostname>:4096/cmdviewVA.html?<hostname>:<array-
id>
<hostname> is the DNS name or IP address of the host to which the
array is connected.
<array-id> is the array’s alias, serial number, device file, or world
wide name.
Running the Management GUI from an OpenView SAM Management
Station
In an OpenView SAM environment, the management GUI should be run from
the SAM screen. Although the Launcher is installed, it should not be used to
run the GUI.
Launching the CV GUI from the OVSAM GUI
The application link to launch the CV GUI from the OVSAM GUI is provided
with the OVSAM product. Just right click on the icon for a VA device
discovered by OVSAM, and select "hp StorageWorks Command View
SDM". There are a few special requirements for this software to work
correctly.
1 The client PC’s web browser should be Internet Explorer 6.0 or later.
2 If you are running the OVSAM user interface on the OVSAM management
station, you may find that you need to modify the file
…\sanmgr\managementserver\config\authorizedClients.dat on
the OVSAM management server. If when you attempt to launch CV you
see the error message “401 Authorization Required. Check server
configuration”, then create a new line in that file with the IP address of the
OVSAM management station.
3 The client PC’s web browser will need to install Sun’s Java 1.4.2 plug-in. It
will be prompted to do so automatically when the CV software is launched.