HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

82 Using the Graphical User Interface

<array-id> is the array’s alias, serial number, device file, or world

wide name.

Running the Launcher from a Web Browser

The Command View SDM Launcher and management GUI can be run from a

web browser. This provides a convenient method of managing an array from

a remote client that does not have the Command View SDM software

installed.

Note Earlier versions of Command View SDM (1.0 and 1.01)

required the installation of a certificate on the browser client for

security. Later versions of Command View SDM (1.02 and

later) no longer require the installation of the certificate. The

applets are now authenticated with built-in certificates.

1 Open a browser on the client.

2 Type the following URL into the address field in the browser:

http://<hostname>:4096/Launcher.html

is the name of the Command View SDM host to which the

array is connected.

Note The Sun Java 1.4.2 plug-in is required to run

Command View SDM on all supported operating systems. If this

component is not installed, you will be prompted to install it at

this point. Follow the instructions to install the Java plug-in, and

then continue with the next step.

On an HP-UX host you will need to go to the following web site

to get the necessary Java plug-in components:

http://www.hp.com/products1/unix/java

3 If the Java Plug-in Security Warning is displayed, select Grant Always to

avoid having the warning displayed again. If you select Grant This

Session, the message is displayed for each signed jar file that is initially

loaded in this session.

4 When the Launcher window is displayed, double-click an array icon to

start the management GUI.