HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

Installing Command View SDM 69
Installing
Command View SDM
The cim.properties File
Modify the parameters in the cim.properties file as indicated in Table 5.
Table 5 Parameters in the cim.properties file
The parameters
LogResponseSeparate, LogFilesCount, and
MaxLogFileSize are not visible when you open the cim.properties file for
the first time. These parameters are visible only when you change the values of
these parameters. To change the values of these parameters, use the following
format:
ParameterName=Value
However, if you re-install SMI-S VA 1.09, the values of all parameters revert to
the default value.
Field Purpose
EnableSSL Set to True to enable SSL. The default value
is True.
LogResponseSeparate Set to True to separate requests and
response packets.
LogFilesCount Indicates the number of log files maintained
by CIMOM. The default number is 5. Modify
this number to increase or decrease the
number of log files. When you initiate the
CIMOM, it starts logging to the
<serverDebugFile>+0 file. (The
serverDebugFile is specified in the
cim.properties file).
When the file size reaches the specified
threshold (MaxLogFileSize), the CIMOM
starts logging into the next file in the sequence
in the ascending order and overwrites the last
modified file.
MaxLogFileSize Maximum size of each log file in bytes. 15
MB is the default size of each log file. You can
modify this number. When a log file reaches
the specified threshold, the CIMOM starts
logging in to the next log file.
Min_Memory_Usage To set the minimum Java heap size for the
CIMOM server. The default value is 20 MB.
Max_Memory_Usage To set the maximum Java heap sezie for the
CIMOM server. The default value is 119 MB.