HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

54 Installing Command View SDM
Verifying the Installation
You can easily verify the success of the Command View SDM software
installation using the following steps.
1 Perform a hardware scan from the host connected to the array to ensure
that the host can see the array. On an HP-UX host, this is done using the
ioscan -fnkdisk command.
2 From a command line on the host or client on which you have installed the
software, enter the following command:
armdsp -i <hostname>
<hostname> identifies the remote host for which information will be
displayed, and is required only when running the command on a client.
3 View the output displayed. It should include an entry similar to the
following for each array connected to the host.
Serial Number:00SG04990114
Alias Name:blue
Device Path:/dev/rscsi/c30t7d0
World Wide Name:50060b00000921d0
Product ID:HP-A6188A
Unique ID:HPA6188A00SG04990114
Note If the anticipated output is not displayed, a problem may have
occurred during installation. See "Solving Problems" on
page 223 for help in isolating and solving the problem.