HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

Installing Command View SDM 47
Installing
Command View SDM
Note If there has been a problem with the software or the array, the
logs should be retained and used to reference for
troubleshooting. If you are certain you will not need to access
the logs, they can be removed.
3 To remove the logs, enter the following three commands:
rm -fR /opt/sanmgr
rm -fR /etc/opt/sanmgr
rm -fR /var/opt/sanmgr
If you are re-installing Command View SDM software, perform the installation
procedures described under "Installing Command View SDM on Linux Red
Hat" on page 43.