HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

Installing Command View SDM 45
Installing
Command View SDM
7 Change directories to the /linux install directory by entering:
cd /tmp/cmdview/
8 Untar the file by entering:
tar -xvf cvsdm_rhel30_v108.tar
9 Go to /tmp/cmdview/SDM entering:
cd /tmp/cmdview/SDM
10 Install the software by entering:
sh install_cmdview
The installation will take several minutes.
Note The Host Agent installer writes a log file to
/tmp/
SanMgrInstall.log
.
The Command View SDM installer writes a log file to
/tmp/CommandViewInstall.log
11 For convenience you may want to add the following line to your path
variable:
export PATH=$PATH:/opt/sanmgr/commandview/client/sbin
12 Log out, then log back in to reset the path.
13 If you saved the configuration files from any earlier Command View SDM
installation, use them to restore the original configuration. Before restoring
the older files, you may want to compare them with newly installed files
(some of the old files may be the same).
Note For installations with multiple IP addresses, see “Selecting a Host
IP Address on Systems with Multiple IP Addresses” earlier in this
chapter.
Note After installation, check the contents of /opt/sanmgr/
hostagent/ config/commIPAddr.txt file. If the correct IP address
is not shown, manually enter the correct IP address and stop and
start the HostAgent.