HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

4
July 2002
Change Page
Updated contents to reflect that a hardcopy of the
Command View SDM User Guide is no longer included.
16
Corrected paths to HA_DIAL_START and HA_DIAL_STOP. 55
Added host port behavior table management to the Command View
VA GUI.
93
Added host port (H1, H2) and disk enclosure port (J1, J2)
subcomponent parameters to the FRU Location Identifier values.
100
Added armdiag command used for advanced troubleshooting. 107
Added new functionality to the armdsp -p option for HP15.
Added -ps option and -vfp option to armdsp command for
displaying VFP settings.
Added the -b and -v options to the armdsp -i command.
119
Added note on host port behavior entry limitations.
Added new options to armhost command to aid in creating the host
port behavior table.
133
Added -pg and -sv options to armlog command to aid in filtering
logs. Also added -xml output option.
137
Added -P, -S, and -pv options to armmgr command. 139
Added -f option to armrecover command to perform a parity scan. 188
Updated Configure and Configure Fiber portions of CVUI menu
map.
206
Added -xml output option to logprn command. 213
Added section "Using Command View SDM on a Serial Port" 241