HP StorageWorks Command View SDM Installation and User Guide (T1086-96023, February 2005)

38 Installing Command View SDM
HP OpenView Storage Area Manager Integration
The Command View SDM software integrates into HP OpenView Storage
Area Manager (SAM) running on a Windows management station. The
process of installing the software on OpenView SAM is the same as on a
standard WIndows environment, however you should be aware of the
following operational differences when installing on an OpenView SAM
management station:
■ The Command View software is only installed on the OpenView SAM
management station.
■ When installing Command View SDM on an OpenView SAM
management station, make sure that SAM is installed before installing
Command View SDM.
■ The OpenView SAM Host Agent must be installed on servers connected to
the arrays that will be managed.
■ When upgrading OpenView SAM, Command View SDM must be
uninstalled before performing the upgrade, and then reinstalled when the
upgrade is complete.
■ The file used to control client access on OpenView SAM is
authorizedClients.dat located in the following directory
\sanmgr\managementserver\config\.
■
The Command View HostAgent and OpenDIAL services are not used on an
OpenView SAM management station. Instead, the OpenView Storage
Management Server service is used for the Command View SDM software.
■ OpenView SAM is supported on the following versions of Command View:
— OVSAM 2.1 is supported with Command View 1.03/1.04
— OVSAM 2.2 is supported with Command View 1.05 and 1.06
— OVSAM 3.0 is supported with Command View 1.06
— OVSAM 3.1 is supported with Command View 1.07
— OVSAM 3.1/3.2 is supported with Command View 1.08
— OVSAM 3.2 or greater is supported with Command View 1.09